A Study of Monodispersed Polydimethylsiloxanes

A series of monodispersed polydimenthylsiloxanes (PDMS) with molecular weights from 3K to 156K were synthesized. The intrinsic viscosity and absolute molecular weight of each monodispersed PDMS was measured and the Mark-Houwink equation for the PDMS series in toluene at 25°C was derived: [eta;]=2.88 × 10^?4 M^0.613. It was proven that the accurate molecular weight determination of polysiloxanes is not possible using polystyrene (PS) standards. It can be achieved either by using a gel permeation chromatographic method with PDMS standards or by a calculation from the Mark-Houwink equation using experimental values of intrinsic viscosity.     

多支链烷基苯磺酸钠水溶液的表面性质

用自制的四种高纯度多支链烷基苯磺酸钠,研究了支链结构对其表面性质的影响.结果表明,随支链烷基碳数增加,临界胶束浓度降低,标准吸附自由能DGadӨ更负;但是,饱和吸附量Γmax却随支链烷基碳数增加而减小,且临界胶束浓度时的表面张力γcmc随吸附量减小而降低,表现出与一般表面活性剂不同的变化趋势.从多支链烷基苯磺酸钠的分子结构特点,解释了随支链烷基碳数增加Γmax和γcmc的变化规律,探讨了分子的独占面积(as)对Γmax及γcmc的影响.     

Influence of demulsifiers of different structures on interfacial dilational properties of an oil-water interface containing surface-active fractions from crude oil

The influences of two commercial demulsifiers that have a straight chain and branch chain, respectively, on the dilational viscoelasticity of an oil-water interfacial film containing surface-active fractions from crude oil were investigated. The branch-chain demulsifier AE-121 could efficiently substitute surface-active fractions of different average molecular weights from the oil-water interface, while straight-chain SP-169 could only efficiently substitute those of large average molecular weight. It was apt to form a mix-adsorption layer with surface-active fractions of small average molecular weight. The results showed that the molecular size (or represented by average molecular weights) of the surface-active fractions was an important factor influencing the reciprocity of demulsifiers and surface-active fractions at the oil-water interface. This effect could be well explained by the difference between sizes of surface-active fraction molecules and vacancies between demulsifier molecules at the interface. The results of SDBS also proved this explanation.     

CuAl2O4 powder synthesis by sol-gel method and its photodegradation property under visible light irradiation

Nanocrystalline spinel CuAl₂O₄ powders were prepared by sol-gel method from nitrate Cu(NO₃)₂·3H₂O, Al(NO₃)₃·9H₂O and complex C₆H₈O₇·H₂O. Sintering was carried out at 400, 500, 600, 700, 800°C respectively for 2 h in air. The XRD patterns started to appear CuAl₂O₄ peaks after sintering of 500°C and consist of only CuAl₂O₄ peaks as spinel crystal after sintering of 700°C. The powders were analyzed by TEM and UV-vis diffuse reflectance spectrum to be round, about 10–30 nm in size and Eg=1.77 eV. Photodegradation property of nanocrystalline CuAl₂O₄ powders was investigated by using methyl orange as model pollutant and mercury lamp (λ>400 nm) as energy source. The results indicated that CuAl₂O₄ powders sintered at 700°C had the excellent visible photocatalytic property. Under the irradiation of visible light, methyl orange could be degraded 97% in 120 min.     

Oxygen binding to sulfur in nitrosylated iron--thiolate complexes: relevance to the Fe-containing nitrile hydratases

Iron-nitrosyl complex containing S-bonded monosulfinate [PPN][(NO)Fe(S,SO2-C6H4)(S,S-C6H4)] (3) has been isolated from sulfur oxygenation of complex [PPN][(NO)Fe(S,S-C6H4)2] (2) which is obtained from addition of NO molecule to [PPN][(C4H8O)Fe(S,S-C6H4)2] (1) in organic solvents. This result reveals that binding of NO to the iron center promotes sulfur oxygenation of iron dithiolates by dioxygen and stabilizes the S-bonded sulfinate iron species. Analysis of the bond angles for complexes 2 and 3 reveals that iron is best described as existing in a distorted trigonal bipyramidal coordination environment surrounded by one NO, three thiolates, and one sulfinate in complex 3, whereas the distorted square pyramidal geometry is adopted in complex 2. Complex 3 further reacts in organic solvents with molecular oxygen in the presence of [PPN][NO2] to produce the dinuclear bis(sulfinate) complex [PPN]2[(NO)Fe(SO2,SO2-C6H4)(S,S-C6H4)]2 (4). Complex 3 showed reaction with PPh3 in THF/CH2Cl2 to yield complex 2 and Ph3PO. Upon photolysis of CH2Cl2 solution of complex 3 under N2 purge at ambient temperature, the UV-vis and IR spectra consistent with the formation of complex 2 demonstrate that complex 2 and 3 are photochemically interconvertible. Obviously, complex 3 is thermally quite stable but is photochemically active toward [O] release. Also described are the X-ray crystal structures of 3 and 4.     

Structural Relationships between the Hemiporphyrazine Macrocyclic Ligand and its Metal Complexes. II.: Planar Neutral Ligand,C26H16N8, and Four Isomorphous Metal Complexes, [M(C26H16N8)(H2O)], M=Mn(II), Co(II), Cu(II), Zn(II)

Crystal and molecular structures of the planar neutral ligand, C₂₆H₁₆N₈, and the four isomorphous five-coordinated metal complexes, [M(C₂₆H₁₆N₈)(H₂O)], M = Mn(II), Co(II), Cu(II), Zn(II), have been determined from three-dimensional X-ray diffraction data. The free ligand hpH₂, C₂₆H₁₆N₈, belongs to the P 2₁/c space group with Z=2, a=4.142(3), b=23.736(6), c=10.338(3) Ä, β=94.66(6)°. The metal complexes monohydrate Mhp-H₂O all belong to the orthorhombic Pcab space group with Z=8. The dimensions are roughly 8.8×19.3×23.7 ų. In each structure, the macrocyclic ligand has an almost planar conformation which differs from the saddle shaped ligand hydrate (hpH₂·H₂O) and the nickel complex [Nihp]⁵. The distances from the center of the macrocyclic ring to the nitrogen atom of the free ligand are 1.907(6) and 2.245(6)Å. The coordination geometry in these four complexes is square pyramidal with a water molecule as an axial ligand. The bond distances of M(II)-O(H₂O), M(II)-N1 (imine), M(II)-N3 (pyridine) are: 2.19(1), 2.00(2), 2.27(2)Å respectively for the manganese complex; 2.08(1), 1.97(1), 2.23(1)Å for the cobalt complex; 2.33(1), 1.92(3), 2.18(1)Å for the copper complex; 2.110(5), 1.964(6), 2.252(6)Å for the zinc complex. The variation of metal-ligand distances can be correlated to the metal d orbital occupancy. A comparison with similar ligands will be presented.     

Tuning Ground States of Bis(triarylamine) Dications: From a Closed‐Shell Singlet to a Diradicaloid with an Excited Triplet State

Three bis(triarylamine) dications were isolated by using weakly coordinating anions. Their electronic structures in the ground state were investigated by various experiments in conjunction with theoretical calculations. The ground‐state electronic structures of these species were tunable by substituent effects, with two of them as closed‐shell singlets and one of them as an open‐shell singlet in the solid state. The excited state of the latter is thermally accessible, indicated by EPR and SQUID measurements. The work provides a new and stable diradicaloid structure motif with an excited triplet sate.     

呼出气体酒精含量探测器检定的注意事项

介绍呼出气体酒精含量探测器的工作原理和国家标准对使用探测器的要求,为确保探测器有效准确的量值溯源,采用呼出气体酒精含量探测器自动检测系统进行检定。该系统能够解决标准气体不易保存和定值容易发生改变的难题,同时控制吹气压力,保证探测器采样的一致性,并列举了检定操作时应注意的问题和细节。